Engenharia de Sistemas

DT-V2710

Novo Firmware

 (v. 3.3.0)

Draytek DT-V2710 Novo Firmware (v. 3.3.2)

Página dos modelos 2710

Download (v.3.3.2)

Loja Draytek

Novas Funcionalidades:

1. Support USB Disk Application (FTP/Samba).
2. “twodns” DDNS service.
3. Support PPPoA pass-through function.
4. Show source MAC address on Syslog for LAN toWAN packets.
5. Support Sierra 597 USB 3G Modem.
6. Add value for VPI/VCI (2/40) to Auto Detection table for Norway.

Correções:

1.   DTMF can't be detected when a DECT phone redials to PSTN phone.
2.   Dial Out Account can not be set to default on DialPlan Setup of WUI.
3.   If the phone is disabled but the phone state is not changed, the phone will not ring when

      receiving PSTN incoming call.
4.   When RFC-2833 with payload type= 96 packet is received, the router will reboot.
5.   SIP memory leakage.
6.   Problem of DECT phone ring after enabling the call barring block IP address.
7.   Call transfer failed for DECT phone.
8.   Problem of setting DECT play dial tone only when the account has been registered.
9.   Problem for semi-attendent CT for VoIP.
10. Can not save DSL settings sometimes after finishing Auto Detection in Quick Start wizard
11. Some problems occurred on WUI.
12. Can not get TR069 parameters after meeting TR069 connection timeout.
13. Firmware upgrade may be failed when upgraded by TR069.
14. UCF can save 12 objects, only.
15. Call filter malfunctioning.
16. Failure of running IP Ping through PPTP of VPN.
17. Problem of L2TP over IPSec for teleworker.
18. Adding UPNP port mapping failed.
19. Connection problem on PPTP NAT pass-through.

Melhoramentos:

1.   Prevent users from dialing 37-39 or 57-59 to DECT phone.
2.   Wildcard '?' can be used in Digit Map.
3.   Allowed VoIP number starting with # for non-IP calls.
4.   Wireless interoperability with Vigor AP700 while using WDS with WPA or WPA2 mode.
5.   Mouse cursor stays on the field of Username in Login page of Web UI.
6.   Add/modify some TR069 parameters.
7.   Router stability against NMAP scan.
8.   Bridge mode may not work after powering off/on.
9.   Add/modify some IM/P2P signatures.
10. Modify QoS command for usage and message display.
11. Remain ARP cache life settings to flash even reboot the router.
12. Increase compatibility with more stun servers.

Novas Funcionalidades:

1.   Suporta função DECT para Vigor2710VDn;

2.   Suporta função backup 3G (não aplicável no Reino Unido);

3.   Upgrade do driver VoIP;

4.   Assinaturas Adicionar/Modificar para bloquear nova versão PPStream;

5.   Assinaturas Adicionar/Modificar para bloquear nova versão UUSee;

6.   Adicionado syslog quando os pacotes são retirados por QoS;

7.   Adicionado comando telnet QoS;

8.   Adicionado comando telnet para receber pacote ARP REPLY (o endereço de origem não coincide com o endereço

      ARP de envio);

9.   Adicionada item de configuração de conta SIP em modo utilizador;

10.  Adicionado botão "seleccionar tudo" nas páginas de objectos IM, P2P, Protocolos e Misc;

11.  Adicionado "Loop Through To PSTN" em estado VoIP no WUI.